Titan Spraybooths

Titan CV (commercial vehicle) Full Down Draught Spraybooths
The Todd Engineering Titan CV series spraybooth is designed to fulfil the requirements for the refinishing of large commercial vehicles and other larger bespoke industrial and commercial processes. The design and layout can be tailored to customer requirements in terms of extraction, access doors, plant layout and internal dimensions.

Layout
The ‘Titan’ has been designed to offer the customer total flexibility on the choice of layout.
In terms of extraction the Titan can be configured as either rear extraction, single/twin side extraction or full downdraught extraction. Internal dimensions can be made to any length, width or height, with various plant positions such as rear, side or roof mounted options.

Construction
The spraybooth cabin is constructed using double skinned rock-wool insulated panels with a white polyester finish both internally and externally, a steel ‘A’ frame superstructure provides primary support for the spraybooth cabin.

Main Doors
The main vehicle entry doors are fully insulated, 3 phase electrically operated roller shutter doors with a white internal/external powder coated finish. The doors are fitted with rubber compression seals across the bottom threshold and internal seals down both vertical guides, an additional seal is provided by nylon brush strips around all internal edges.

Personnel Door
Additional personnel doors can be fitted to any wall panel, to provide a safe fire escape route. The doors are fitted with self-closing catches, rubber compression seals, full length viewing window, aluminium white powder coated hinges and door handles.

Lighting
The cabin is superbly lit with high level corner mounted light pods which are angled to reduce glare and shadowing, these pods are outfitted with a state of the art LED lighting system that gives illumination levels in excess of 1500 lux through the use of high output tubes. These tubes consume 50% less energy than conventional tubes with an equivalent light output. The high frequency ballasts provide a flicker free start and extended life for the unit as well as the tubes.

Input Filtration
All input air into the spray booth is filtered through high quality EU5 filter media; this is housed in the full size ceiling air input plenum.

Performance
The spraybooth plant work is fitted with direct drive aerofoil backwards bladed centrifugal fans to achieve minimum design airflow rate of 35000m³/hr. This provides a rate of 2 air changes per minute within the cabin, with extracted air being exhausted to atmosphere. The extraction system is fitted with two stage filtration incorporating EU2 50mm green paint stop filter and EU3 blue pre-filter; this ensures that emissions meet EPA requirements.

Heating
The spraybooth is fitted with a direct fired gas/LPG burner’s with an output of 220kW or 750,000Btu’s/hr; this allows input air to be rapidly heated to the pre-set temperature on the control panel.

Control Panel
The control panel provides operating cycle selection for spray, hydracure and bake modes, automatic bake timing with cool-down facility, lighting control, temperature controller readouts for spray,
hydracure and bake cycles, Magnehelic pressure monitoring with positive pressure alarm and emergency shutdown. The standard power requirements are three phase 63A, 400 volt, 50 Hz + Neutral.

Todd Engineering